Panel screw storm shutters can be easily built at home. When you build panel screw storm, you are fulfilling one of the most crucial steps involved in hurricane preparedness. According to the Federal Emergency Management Agency, the hurricane is a tropical cyclone during which wind speeds exceed an incredible 130 miles per hour. After defining hurricane, FEMA further states the best way to protect your house: build hurricane shutters, even it is Panel screw storm shutter. When you build these shutters, you are not just safeguarding your windows and doors, but the entire house. As stated earlier, wind can damage the inside of your house only if it gains entry. This happens when the wind shatters the glass of your windows. Windowpanes are also broken when the wind hurls heavy things at them in the absence of Panel screw storm. Once inside, the wind quickly builds up tremendous pressure on the roof and the walls. As a result, the wall develops cracks and the rooftop collapses or gets blown away, depending upon the material and the design used to build it. When people build this storm shutter, they stop an entire series of events that damage, or worse, devastate the homes they cared for so much. That is why panel screw storm plays such an important role in limiting damage by hurricane.





As stated in the preceding answer, Panel screw storm can be built with plywood is a very affordable option for those who do not want to go in for professionally built hurricane shutters. To build this shutter at home, take plywood planks or panels that are at least half-an-inch in thickness. Now cut them out to fit the window size. Screw barrel bolt at regular intervals. The barrel bolts can be three or four-inch heavy-duty barrel bolts. For a small or medium Panel screw storm, you can do with four-barrel bolts. Bigger panel screw storm shutters will need more barrel bolts. Drill holes into the windowsill sides. Bolt up when needed. Otherwise store the shutters in a dry place. Never wait for hurricane warnings and then start to build Panel screw storm.





Now place the plywood up against the window, and mark where each barrel bolt slides up against the wall. Once you've made all the marks, remove the panel and drill the boltholes into the concrete. If you need to place the panels on the outside exterior wall then instead of cutting the plywood to fit inside the window inset, it should be cut to leave at least four inches around the opening. Make necessary adjustments. Bolt up when needed. Otherwise store the shutters in a dry place. Never wait for hurricane warnings and then start to build panel screw storm shutter. The best time to build this shutter is when plans the layout and design of the house. If you had skipped to build this panel shutter during the initial stages, do not wait for any special occasion. Build hurricane shutter NOW!